中山市小欖鎮君菱電子銷售中心主營接近開關，光電開關，光纖放大器，超聲播傳感器，移位傳感器，壓力傳感器，傳感器，繼電器，斷路器，

接觸器，等電器配件.主要銷售的品牌有歐姆龍OMRON，奧托尼克斯AUTONICS，基恩士KEYENCEN，神視SUNX，倍加福P F，施耐德Sch

neider，ABB，三菱MITSUBISHI，富士FUJI，等等
中山市君菱電子辦公電話：0760-23790206 18022090710 傳真：0760-22556528

CJX4-6021Kd 切換電容器交流接觸器々CJX4-kd系列切換電容器接觸器
CJX4-kd Range Contactor for Capacitor Switching
一、用途 APPLICATION
CJX4-kd系列切換電容器接觸器（以下簡稱接觸器）主要用于交流50Hz（或60Hz）， 額定絕緣電壓為690V， 在AC-6b使用類別下，額定工作電壓為400V時額定工作電流至87A的低壓無功功率補償設備中，通斷低壓無功功率補 償用的電容器組，用以調整電系統的功率因數COSΦ值。接觸器附有抑制涌流 裝置，能有效地減少合閘涌流對電容器組的沖擊和降低操作過電壓。
CJX4-Kd range contactor for capacitor switching in used in AC 50Hz(or
60Hz), rated insulation voltage 690V, rated current is up to 87A under rated voltage 400V and category AC-6b of low-voltage no power compensation device, for adjust power factor COSΦContactor attached inhibit flow device that can effectively reduce impact from trip flow and reduce operation over- voltage.
二、結構特點 STRUCTURE FEATURE
△ 接觸器為防護式，動作機構為直動式，觸頭為雙斷點。
Contactor is protection type, direct-moving and double breaking contact terminals;
△ 接觸器由一臺CSC1系列交流接觸器，一臺轉換觸頭組和六根限流電阻線等零部 件組成，轉換觸頭組掛接在CSC1系列交流接觸器的上方，主觸頭系統分上、下 兩層布置，上主觸頭接通瞬間后自行斷開復位，下主觸頭繼續閉合到位。 Contactor composite by a GSC1 AC contactor、 a conversion contact group、 six limiting current resistor line and other component parts, conversion contact group articulated on the above of GSC1 range AC contact, the main contact system arranged on up-low level. Up main contact disconnect and reset after making, the next main contact contains closed reset.
△ 在接觸器兩側可加裝輔助觸頭組（F3－20d1）以增加輔助觸頭對數。
Both sides can be added auxiliary contact （F3－20d1） for add the volume of auxiliary contact;
■ 觸頭數量：Contact volume
△ 接觸器具有三對常開主觸頭，每對主觸頭分上、下兩層，每對上主觸頭與兩根 限流電阻線串聯后與一對下主觸頭對應并聯。接觸器本身還具有兩對輔助觸頭
（上層一對，下層一對，僅CJX4-25kd～40kd）或三對輔助觸頭（上層一對， 下層兩對，僅CJX4-50kd～125kd）。
Contactor has three pairs of normally open main contact, every main contact arranged to upper and lower level, each upper main contact series with limiting resistor line, than counterparts with one lower main contact. Contactor itself also has two pairs of auxiliary contacts (one pair upper and one pair lower, only to CJX4-25kd～ 40kd), or three pairs of auxiliary contacts (one pair upper and two pairs lower, only to CJX4-50kd～125kd）.
△ 本系列產品的安裝尺寸均與GSC1-d系列交流接觸器對應相同。
Installation dimensions of the range product, all small GSC1-d range Ac contactor.
三、工作原理 WORKING PRINCIPLE
當控制回路通電后，接觸器吸合，串入限流電阻線的上主觸頭先于下主觸頭 接通，從而達到抑制涌流作用，完成后瞬間斷開復位，其間下主觸頭進入正常 工作，而斷開回路時則由下主觸頭完成，各司其責。因限流電阻瞬間接入，所 以不會造成長期的電力浪費和燒損電阻線等現象。
When control circle is making, the contactor will pull in, the upper main contact with limiting resistor line making before the lower main contact, to achieve to inhibit flow, after that, the upper main contact breaking instantly and reset. At the same time, the lower main contact start normally working, lower main contact should complete breaking circle. All have themselves responsibility. Because of the limiting resistor instantly accession, it will not cause the phenomenon of long-term electricity waste and burning resistance line.
四、工作條件和安裝條件
WORKING CONDITION AND INSTALLATION WAY

△ 周圍空氣溫度：-5℃～ 40℃，24小時的平均值不超過 3 5℃。
Ambient temperature: -5℃～ 40℃. Average temperature ≤ 3 5℃ in 24H;
△ 安裝地點海拔不超過2000m。Elevation ≤2000m
△ 安裝地點的空氣相對濕度在較高溫度為 40℃時不超過50%，在較低溫度下可以 有較高的相對濕度濕月的月平均較低溫度不超過 25℃，該月的月平均較大相 對濕度不超過90%；由于溫度變化發生在產品上的凝露情況必須采取措施。 Relative humidity is not exceeding 50% at the maximum ambient temperature 40℃ . With lower temperature, higher humidity would be permitted. And average maximum relative humidity ≤ 90% in the most humidity month, at the same time, the average minimum temperature should ≤ 25℃, and should give consideration to dews on the good surface,which would appear due to temperature change.
△ 接觸器應安裝和使用在無搖擺、沖擊和振動的地方。
Contactor should be installed at no significant sharking or vibration place.
△ 接 觸 器 應 按 正 常 位 置 安 裝 ， 安 裝 面 與 垂 直 面 傾 斜 度 不 超 過