PIC18F66J65解密 PIC18F66J65芯片解密 PIC18F66J65單片機解密
電子元器件 集成電路開發與設計
、快速、準確 不成功不收費的解密
Selectable System Clock derived from Single
25 MHz External Source:
- 2.778 to 41.667 MHz
? Internal 31 kHz Oscillator
? Secondary Oscillator using Timer1 @ 32 kHz
? Fail-Safe Clock Monitor:
- Allows for safe shutdown if oscillator stops
? Two-Speed Oscillator Start-up
External Memory Bus
(100-pin devices only):
? Address Capability of up to 2 Mbytes
? 8-Bit or 16-Bit Interface
? 12-Bit, 16-Bit and 20-Bit Addressing modes
Peripheral Highlights:
? High-Current Sink/Source: 25 mA/25 mA on PORTB
and PORTC
? Five Timer modules (Timer0 to Timer4)
? Four External Interrupt pins
? Two Capture/Compare/PWM (CCP) modules
? Three Enhanced Capture/Compare/PWM (ECCP)
modules:
- One, two or four PWM outputs
- Selectable polarity
- Programmable dead time
- Auto-shutdown and auto-restart
? Up to Two Master Synchronous Serial Port (MSSP)
modules supporting SPI (all 4 modes) and I2C?
Master and Slave modes
? Up to Two Enhanced USART modules:
- Supports RS-485, RS-232 and LIN/J2602
- Auto-wake-up on Start bit
- Auto-Baud Detect (ABD)
? 10-Bit, Up to 16-Channel Analog-to-Digital Converter
module (A/D):
- Auto-acquisition capability
- Conversion available during Sleep
? Dual Analog Comparators with Input Multiplexing
? Parallel Slave Port (PSP) module
(100-pin devices only)
Special Microcontroller Features:
? 5.5V Tolerant Inputs (digital-only pins)
? Low-Power, High-Speed CMOS Flash Technology:
- Self-reprogrammable under software control
? C compiler Optimized Architecture for Reentrant Code
? Power Management Features:
- Run: CPU on, peripherals on
- Idle: CPU off, peripherals on
- Sleep: CPU off, peripherals off
? Priority Levels for Interrupts
? 8 x 8 Single-Cycle Hardware Multiplier
? Extended Watchdog Timer (WDT):
- Programmable period from 4 ms to 134s
? Single-Supply 3.3V In-Circuit Serial Programming?
(ICSP?) via Two Pins
? In-Circuit Debug (ICD) with 3 Breakpoints via
Two Pins
? Operating Voltage Range of 2.35V to 3.6V (3.1V to
3.6V using Ethernet module)
? On-Chip 2.5V Regulator